Oil Capacity Of 2020 Ford Edge Cylinder Engine(+ Best Oils)

Using the correct oil volume ensures that all engine components, such as pistons, bearings, and turbo bearings in the EcoBoost engines, receive proper lubrication. Running the engine with too little oil can cause premature wear, overheating, or even engine damage, while too much oil may lead to foaming, oil pressure problems, and leaks.

Oil Capacity Of 2020 Ford Edge Cylinder Engine

The 2020 Ford Edge holds approximately 5.7 quarts of SAE 5W‑30 synthetic oil with a new filter, while the 2.7‑liter V6 EcoBoost engine requires about 6.0 quarts with a filter.

Proper oil capacity is essential to ensure engine lubrication, protect turbo components, and maintain performance. It is always recommended to check the dipstick after filling to avoid underfilling or overfilling.

Here is a breakdown of the recommended oil capacities for the 2020 Ford Edge based on engine type:

Engine TypeOil Capacity (with filter)

2.0 L EcoBoost (4‑cyl) 5.7 U.S. quarts (approximately 5.4 liters)

2.7 L EcoBoost (V6) 6.0 U.S. quarts (approximately 5.7 liters)

For both engines, the recommended oil type is SAE 5W‑30 synthetic oil that meets the manufacturer’s specifications.

Best Engine Oils for the 2020 Ford Edge

Click the Links Below to Check the Latest Prices on AMAZON

1. Mobil 1 Extended Performance Full Synthetic Motor Oil 5W-30

Features:

Provides long‑life protection, allowing up to 20,000 miles between oil changes.
Excellent high-temperature protection for turbocharged engines and strong cold-start performance.
Helps prevent sludge, deposits, and engine wear, keeping pistons and turbo bearings clean.

2. Pennzoil Platinum Full Synthetic 5W-30 Motor Oil

Features:

Made with a gas-to-liquid base oil for superior cleanliness and stability, reducing engine deposits.
Performs well in extreme temperatures, flowing easily during cold starts and remaining stable under high heat.
Offers strong wear protection while helping maintain fuel efficiency and engine performance.

3. Pennzoil Platinum Full Synthetic 5W-30 Motor Oil

Features:

Same performance benefits as the standard Pennzoil Platinum oil, including deposit control and temperature stability.
Comes as a multi-pack, offering convenience and cost savings for multiple oil changes.
Ideal for DIY maintenance, providing spare jugs for future oil changes.

Why Oil Capacity May Vary Slightly

You might notice slight differences in published oil capacities, such as 5.5 or 6 quarts for certain engines. These variations are usually due to:

Whether the oil filter is replaced during the oil change. Some capacities refer to the engine alone, while others include the filter.
Slight differences in engine sub‑variants or equipment can affect oil pan volume.
Rounding differences in reporting, where numbers are approximated.

Because of these variations, it’s best to use the manufacturer’s recommended capacity as a guideline and confirm the level using the dipstick after filling.

How to Properly Change Oil on a 2020 Ford Edge

Performing an oil change correctly ensures your engine stays healthy. Here’s a step‑by‑step guide:

Park on a level surface and let the engine cool. Warm oil drains more easily, but a cooler engine reduces the risk of burns.
Drain the old oil. Remove the drain plug on the oil pan and let the old oil drain completely into a container.
Replace the oil filter. Always install a new filter to ensure proper filtration of contaminants.
Refill with the correct oil. Add approximately 5.7 quarts of oil for the 2.0 L engine or 6.0 quarts for the 2.7 L engine.
Start the engine briefly. Run for a minute or two, then shut off the engine to allow oil to settle.
Check the oil level with the dipstick. Ensure it sits between the “Add” and “Full” marks, adding small amounts if needed.
Dispose of the old oil and filter properly. Used oil is hazardous and should be recycled at a designated facility.

Oil Change Interval and Recommendations

For normal driving conditions, Ford recommends changing the oil in a 2020 Edge every 7,500 miles. Under severe driving conditions, such as frequent short trips, towing, dusty roads, or stop-and-go traffic, more frequent changes, such as every 5,000 miles, are advisable.

Always use SAE 5W‑30 synthetic oil that meets Ford specifications. Synthetic oil flows better at startup, resists breakdown under high temperatures, and provides superior protection for turbocharged engines.

Common Mistakes to Avoid

When changing oil in a 2020 Ford Edge, avoid these mistakes:

Underfilling the engine. Using less oil than recommended can starve engine components of lubrication, especially in turbocharged engines.
Overfilling. Too much oil can cause foaming, pressure issues, and leaks.
Neglecting the oil filter. A dirty filter reduces oil flow and accelerates engine wear.
Using the wrong oil type or viscosity. Using thick or conventional oil in a turbo engine can lead to poor performance and engine stress.

FAQs

How much oil does a 2020 Ford Edge take?

The 2020 Ford Edge 2.0 L EcoBoost 4‑cylinder engine takes approximately 5.7 quarts (5.4 liters) of SAE 5W‑30 synthetic oil with a new filter, while the 2.7 L V6 EcoBoost engine requires about 6.0 quarts (5.7 liters) with a filter.

What is the 2020 Ford Edge 2.0 L 4 cylinder engine?

The 2.0 L 4‑cylinder engine in the 2020 Ford Edge is a turbocharged EcoBoost engine designed for efficiency and performance. It delivers a balance of power and fuel economy and features modern technology like direct injection and a turbocharger to provide strong acceleration while maintaining lower fuel consumption.

How much oil does a 3.5 L V6 Ford Edge take?

The 3.5 L V6 engine, which is available in some Ford Edge models, typically requires around 6.0 quarts (5.7 liters) of engine oil with a new filter, using SAE 5W‑30 synthetic oil for proper lubrication and performance.

How much oil does a 3.6 liter V6 take?

For the 3.6 L V6 engine in Ford Edge models, the recommended oil capacity is also approximately 6.0 quarts (5.7 liters) with a new filter. Using the correct oil type and amount ensures proper engine lubrication and protects internal components.

How many litres of oil does a Ford Edge take?

Depending on the engine, a Ford Edge generally takes between 5.4 liters (2.0 L 4‑cylinder EcoBoost) and 5.7 liters (V6 engines such as 2.7 L, 3.5 L, or 3.6 L) of engine oil with a new filter, all using SAE 5W‑30 synthetic oil for optimal performance.

Final Thoughts

Knowing the correct oil capacity and using the proper oil type are simple but effective ways to extend the life of your 2020 Ford Edge. For the 2.0 L EcoBoost, the capacity is approximately 5.7 quarts, while the 2.7 L V6 holds about 6 quarts with a new filter.

By following a regular maintenance schedule, checking the oil level after filling, and always using the recommended synthetic oil, you can keep your engine running smoothly, reduce wear, and ensure long-term reliability. Proper oil care is one of the easiest ways to protect your vehicle and maintain its performance for many years.